ÖZKARDEŞLER · Rule selection

Point size and height in cutting rule: Two measurements, two different tasks

The phrase "two-point rule" states the thickness; it does not state the height of the rule. Writing these two measurements separately in a cutting die order is the first step of machine and material matching.

Height is not the same thing as the visible section on the base

The height of the steel rule is the total measurement from its base to the cutting edge. The section remaining above the die board relates to how the rule is seated in the base and the base thickness. Therefore, describing the cutting-rule height solely by the protrusion visible above the board can be misleading.

The machine's tooling setup, counter-cutting surface, and cutting objective are evaluated together. Carrying a common height to all machines or determining the cutting-rule height solely from the paperboard grammage is not a correct ordering method.

Points define the thickness of the steel rule

Rule suppliers' catalogues provide points and millimeters together. For example, 1,5 pt may be listed as approximately 0,53 mm, and 2 pt as approximately 0,71 mm. Base your final order on the supplier's relevant product dimension and tolerance.

Choosing a thicker rule does not automatically mean better cutting. Bending geometry, close contours, the material to be cut, and the bevel form are also part of the selection. The requirements of a fine form and a large corrugated board contour may not be the same.

Do not limit the barcode rule to its commercial name

Expressions like "barcode rule" or "12 rule" can be used in internal workshop communication. However, do not view these as an immutable standard defining all label jobs. The order must state the actual height, thickness, material structure, and through-cutting or kiss-cutting target.

Bevel coating is also a separate specification. The technical definition and suitability of the coating used are evaluated on a product basis; service life or cutting quality is not guaranteed solely by the coating name.

Short order note for rule selection

  • Exact machine model and existing tooling setup.
  • Cutting-rule height and points; product/series information if known.
  • Material thickness, layer structure, and coating.
  • Through-cutting, kiss-cutting, or different line tasks.
  • Critical contours, production run quantity, and previous cutting issue.

If you have a record of the previous cutting die, share it. Let the Özkardeşler team evaluate the record along with the material and machine information of the new job to clarify the quote scope.

Frequently asked questions

Does the point value indicate the hardness of the rule?

No. Thickness, body hardness, and edge hardness are different product specifications.

Does barcode cutting always require a 12 mm rule?

No. The appropriate dimension is verified with the machine, tooling setup, material, and cutting objective. The commercial name alone is not sufficient.

Explore other cutting die technical guides

Material- and product-specific guides