How should you share material information?
Specify the flute type, single-wall or double-wall structure, and actual thickness if possible. Note additional processes such as coating, printing, and lamination. Inspection via a physical sample may be required even for different sheets of the same nominal material grade.
Cutting, creasing, and sheet behavior
As well as completing the cutting line, the controlled folding of the creasing areas and the separation of the sheet after cutting are also important. The creasing solution is evaluated according to the material structure. Excessive pressure should not be expected to solve every issue; material and tooling selection are examined together.
Flatbed and rotary dies are not prepared with the same technical knowledge
In flatbed cutting, machine format, chase, and sheet layout stand out. In rotary applications, cylinder diameter, mounting arrangement, and machine-specific information are also required. We further clarify the rotary project scope with a technical evaluation. We do not make a diameter or compatibility commitment without machine information.
Ejection and stripping in output quality
Ejection rubbers help the material release from the rule. Waste areas, small openings, and nick locations are evaluated together with the stripping flow. The effect of a modification in the die on sheet transport and separation behavior must be reviewed.
Short checklist for a quote
Technical drawing or dimensioned sample information; flute type and material thickness; sheet size; machine brand/model; layout and stripping requirement; expected job scope. Sharing this information in the same request helps us identify missing details earlier.
Compare the pre-cutting and post-cutting samples together
When crushing, incomplete cutting, or irregular folding is observed, sending only a photo of the problematic box limits the inspection. When the uncut sheet from the same material, the cut flat sample, and the erected box are compared together, it is clearer to read in which region the change has occurred.
Mark the feeding edge and grain or flute direction on the sample. State whether the issue repeats across the entire sheet, in a specific position, or in a narrow area. If the material batch or lamination structure has changed, share this information along with the existing die record.
Instead of blaming the die for all defects based on a single surface mark, material, tooling, and production conditions are examined together. The flute direction and crushing guide helps you prepare your sample file.
Complete the cutting check by erecting the box
Completing the cutting line does not alone show that the box will be erected in the desired form. Check locks, flaps, lids, and joint areas with the actual product or approved assembly sample. In laminated structures, the surface layer and folding area must also be included in the evaluation.
- Flat sample: Read the outer contour, slits, and creasing positions in the same orientation.
- Assembled box: Examine flap matching, locks, and product placement.
- Production output: Record the separation of small waste and sheet transport separately.
Waste stripping and separating products from each other are different tasks. Convey the difference between stripping and blanking accurately to the quote scope. For stand or display projects, also share the assembly sequence and part matching along with the drawing.
Frequently asked questions
Is the flute type alone sufficient?
No. Actual thickness, sheet structure, and surface treatments are also important in the evaluation.
What additional information is required for a rotary die?
Cylinder diameter, machine brand/model, mounting arrangement, and technical details of the existing tooling are necessary for a start. The application scope is further clarified.