ÖZKARDEŞLER · Gaskets and industrial parts

How are hole centers and sample checks planned in gasket cutting dies?

While the outer shape of a gasket may look the same, hole centers can yield different results during assembly. Therefore, dimensional drawings, material definitions, and the application area of the part are just as important as the sample when requesting a gasket cutting die.

Define the reference for dimensions

Hole diameters, distances between centers, and the outer contour must be described using the same coordinate or reference system. Show on the drawing between which points critical dimensions are taken. Measurement results and acceptance ranges are different information; tolerances are written based on design requirements.

An old gasket may have been used, compressed, or deformed. Instead of taking a photograph of such a part alone as the new product dimension, compare it with technical drawings and assembly surface information, if available.

Share the exact definition of the material

The trade name of rubber, felt, or another sheet material is starting information. The product code, thickness, and uncut sample complete the evaluation. Environmental and operating conditions are evaluated by the competent technical team during material selection.

Preparing a cutting die does not automatically verify the suitability of the material for a specific fluid or operating condition. Functional requirements and cutting geometry must be described separately in the same quotation file.

Internal waste and measurement methods are also part of the plan

Internal waste from small holes, narrow rings, and closely spaced contours are shown separately in tooling evaluations. Preserving the geometry is just as important as the clean separation of the cut part during sample control.

The force applied during measurement and the condition of the part in flexible materials can affect the result. The control method, critical dimensions, and sample acceptance conditions must be defined together prior to production.

Information package for gasket dies

  • Revised drawings and acceptance ranges for critical dimensions.
  • Material product code, thickness, and uncut sample.
  • Machine model and part quantities.
  • Internal waste, hole patterns, and assembly references.
  • Expected measurement and approval methods during sample control.

Evaluate your gasket die requirements through this information with Özkardeşler. Let us build the quotation scope without confusing part dimensions with functional requirements.

Frequently asked questions

Can an old gasket serve as a dimensional reference on its own?

Usage-induced changes must be examined. It needs to be evaluated together with drawing and assembly references.

Does a cutting die guarantee sealing?

Sealing is related to the material, design, assembly, and operating conditions. Die geometry is only one part of this evaluation.

Explore other cutting die technical guides

Technical preparation and application guides

Technical preparation and application guides