ÖZKARDEŞLER · Thermoforming and blister packaging
How do you clarify cutting lines with samples in thermoforming trim dies?
A photograph of a formed plastic part may not fully explain where and in which plane its perimeter will be cut. When requesting a thermoforming trim die, the actual sample, cutting line, and machine references must be read together.
Describe forming and perimeter cutting separately
The tooling that forms the part and the cutting tooling that separates the perimeter of the resulting part may have different functions. Specify which stage you need a die for: forming, perimeter cutting, or re-evaluating existing cutting tooling.
Also share how the line connects the tooling and how the part is positioned during cutting. The machine model, operational setup, and existing tooling drawings substantiate this information.
Show the surfaces to be cut and protected on the sample
Show the cutting line on the marked sample and dimensioned drawing together. If there are seating edges, flanges, lid interfaces, or areas combining with cards, define these as separate references. A top-view photograph of the sample alone may not explain height and seating information.
Compare different production samples if possible. Variability between samples helps evaluate whether dimensions derived from a single part represent the entire production.
Record material and edge quality expectations
The exact polymer definition, sheet information, and the condition of the part in the cutting zone are included in the evaluation. If there is cracking, whitening, or improper edge separation, the location of the issue and which samples it repeats in must be marked.
For details such as hang holes, the relationship between the apparatus to be used and the finished product is also shown. Rather than assuming a fixed euro hole or edge allowance is suitable for all products, proceed based on actual geometry and usage.
Trim brief to be forwarded to Özkardeşler
- Actual sample and dimensioned part drawing.
- Marked cutting line, plane, and seating references.
- Machine model and existing tooling connections.
- Material information and expected edge features.
- Problematic samples, latest changes, and revisions, if any.
Let us evaluate your thermoforming cutting die requirements together with sample and machine data. Let us clarify which tooling and control are necessary prior to quotation.
Frequently asked questions
Are thermoforming dies and trim dies the same tooling?
They can be separate toolings depending on the task and system setup. The requested process must be stated from the beginning.
Can a precise cutting allowance be derived from a blister photograph?
Photographs assist with preliminary evaluation. Cutting allowances and references are verified through actual samples, drawings, and usage relationships.
Take the assembly surface as a reference for blisters and euro holes
In blister cutting dies, the center of the hanging or euro hole is dimensioned together with the outer perimeter. The flange to be cut, the seating surface, and the sealing area, if any, should not be interpreted as the same line. Mark the surface from which the vacuum-formed sample will be supported, the cutting line, and the area where cracking is observed. Compare clean samples and problematic samples in the same reference direction.
Tolerance and dimensional control in cutting dies: what and where should you measure?
