ÖZKARDEŞLER · Dimension control

Tolerance and dimensional control in cutting dies: what and where should you measure?

The rule placement of the die, the outer dimension of the flat-cut part, and the inner dimension of the folded box are different control points. The tolerance belonging to one is not automatically transferred to the other. Specify whether the inner or outer dimension of the product is requested in the drawing, and from which reference the cutting or creasing line will be measured. Particularly mark functional areas such as windows, hole centers, and locks.

Match the control plan with the packaging structure: folding and lock dimensions in paperboard cutting dies; sheet structure, flute direction, and crushing expectation in corrugated board cutting dies are evaluated separately. Indicate which production stage critical dimensions belong to in the same file.

Verify scale and unit of measurement

Although the PDF view looks correct, the scale or unit may be wrong. Put at least one written control dimension in the file and compare the acquired vector geometry against it. The fit-to-page option 1:1 when printing may alter the output. A photo's perspective and the pixel dimension of a screen capture must not be used in place of production geometry.

Determine the acceptance limit based on the job

There is no single plus/minus value applicable to every die and every material. Critical dimension, permitted deviation, measurement method, sample condition to be measured, and sampling plan are decided together. The manufacturer tolerance of the cutting rule is not the same as the total dimensional tolerance of the finished packaging. Material behavior, machine references, and folding results are evaluated separately.

Record the first part with the same references

Keep the nominal dimension and measured value in the same table. Record whether the deviation is seen in all cavities or a single cavity, and the feed direction. When the material batch or revision changes, do not consider the old measurement as proof for the new job. You can clarify the inspection scope prior to the quotation by forwarding your acceptance expectation along with critical dimensions to Özkardeşler.

Checklist for quotation and evaluation

  • Approved drawing and clear unit of measurement
  • Critical dimensions, starting reference, and acceptance limit
  • Material, machine, and sample condition
  • Position number, measured value and inspection date

Explore other cutting die technical guides