ÖZKARDEŞLER · Label diagnosis

Does the label cutting error repeat on the same sheet layout? Prepare an error map before taking photos

When an uncut corner is observed on a sheet, the most useful initial information is where and how often the defect recurs. A simple layout map prepared to inspect the cutting die turns scattered photos into a comparable technical record.

Define the sheet and its orientation

Mark the feed edge with an arrow; assign row and column numbers to the layouts. When indicating the problematic corner, also write which face of the print you are looking at. The photo of the cutting die and the cut sheet must be readable in the same orientation.

Recording multiple production samples in the same way helps distinguish a one-off material defect from a recurring pattern. The defect map narrows down the inspection; it is not used alone as definitive proof of the cause.

Name symptoms separately

Incomplete cutting, difficult stripping, liner cutting and adhesive buildup are different observations. Writing them all as "label not cutting" makes comparison difficult. Note the symptom you see in each layout and in how many samples it repeats.

Close-up imagery shows detail, while an overall photo of the sheet explains location. Share both with the same record. Marking should be done in a way that does not obscure the actual defect.

Separate fixed position from variable position

A recurring symptom in the same corner can guide the inspection of the local cutting rule, joint, fit or counterplate. For defects that shift across different sheets, topics such as feeding, material and pressure distribution are also compared.

If any changes were made to the material, lamination or tooling after the previous successful job, add this to the record. Keep the relationship between the changes made and the results visible instead of making multiple interventions at once.

Complete the inspection package

  • Production samples with marked orientation and layouts.
  • General photo of the cutting die and close-up of the relevant contour.
  • Material product code, liner and surface treatments.
  • Machine model, file version and latest changes.

Reach Özkardeşler with these records. Let us determine the next inspection step together by examining the cutting die and production conditions over the same reference.

Frequently asked questions

Is the cutting die definitely defective if there is an error in the same layout?

No. Location is an important clue; the relevant cutting rule, fit and counterplate are examined together.

Is a single photo enough?

Along with the general and close-up views, orientation information and repeating samples strengthen the evaluation.

Explore other cutting die technical guides