ÖZKARDEŞLER · Label

Up-placement in a label cutting die: Is a higher quantity always better?

Fitting one more label onto the sheet may seem tempting. However, a good layout is one that can also run smoothly during printing, cutting, and waste stripping. Share not only the number of ups in the cutting die quote, but also the path the sheet will follow throughout production.

Read the working limits before sheet dimensions

The usable area of the machine determines the layout boundaries for the feeding edge, clamping mechanism, and print reference. Do not assume that the entire raw sheet can be used for cutting. If an existing machine template is available, submit it along with the drawing, and also specify which model the template belongs to.

For custom-shaped labels, concave turns and converging contours are also taken into account. Two labels with identical outer dimensions may not necessarily share the same creasing and mounting requirements.

Print direction and waste stripping method affect the layout

Changing the print direction may require modifying the artwork or production references as well. For self-adhesive jobs, how the matrix waste will be removed and how the label will be presented on the liner must be described separately. Whether a very narrow gap is suitable is evaluated based on the actual contour and material.

A common cutting line or close layout is not suitable for every job. The combination of contours must be approved along with the cutting type, printing tolerance, and stripping expectation. Fitting on the page alone does not prove that it will run successfully in production.

Simplify quality control by numbering the cavities

Assigning cavity numbers with rows and columns on a trial sheet makes it easier to match defects with the cutting die. For example, a corner issue remaining only in the third cavity of the second row versus a cutting issue shifting to a different spot on each sheet requires different investigations.

Include the feeding direction on the numbered sheet as well. If the general view of the cutting die and a close-up of the problematic area are recorded in the same direction, comparison becomes clearer. The cavity map helps with diagnosis; it does not definitively prove the cause of the defect on its own.

What should a layout quote include?

  • Approved single label contour and desired direction.
  • Sheet size, usable machine area, and feeding edge.
  • Preferred number of cavities; alternative layout if any.
  • Through/kiss-cutting and matrix waste stripping expectation.
  • Total production quantity and material specification.

Send not only the label size but also the current sheet plan to Özkardeşler. Let us evaluate space utilization and die production requirements together.

Frequently asked questions

Is the plan with the most cavities always the most cost-effective plan?

Not always. Die preparation, printing, stripping, and waste conditions enter into the overall evaluation.

Does the print run substitute for the number of cavities?

No. Print run describes the production quantity, while the number of cavities describes the number of products on a single sheet.

Explore other cutting die technical guides