ÖZKARDEŞLER · Gasket applications
Show the material layer and mounting direction together in insulation part cutting dies
Cutting a gasket to the correct contour does not mean it will be mounted in the correct direction. The adhesive face, coating layers, and hole positions must also appear in the drawing. It is important to record the cutting geometry separately from the application function of the part during die preparation.
Define the material structure with the product code
If foam, felt, film, or a multilayer structure is involved, list all layers in order. The material supplier's product code and actual sample provide a clearer reference than a generic material name. Specify which structure the thickness belongs to.
If there is an adhesive and a protective liner, explain which ones will be completely cut and which ones will be preserved. When the cutting target changes, the tooling preparation is also re-evaluated.
Add the assembly reference to the technical drawing
Show the front/rear face, right/left part, and assembly direction. Numbering holes, slits, and narrow connections makes acceptance inspection easier. Dimensioning must describe the assembly references with which the part will actually mate.
The material may compress or stretch; therefore, record the condition under which the sample was measured. Instead of promising the same tolerance for every material, critical dimensions and acceptance conditions should be determined at the quotation stage.
Separate cutting approval from application suitability
A sample correctly cut with a die does not alone prove thermal, acoustic, or electrical insulation performance. These properties must be verified separately under material and product requirements. Clearly define the desired geometric result during the die consultation.
- Defined material code and sample for the layers.
- Dimensioned drawing, face, and assembly direction.
- Information on the liner to be cut/preserved.
- Machine, quantity, and acceptable critical dimensions.
Review your gasket request through this technical package with Özkardeşler. Let us clarify the appropriate tooling scope along with the sample and assembly expectation.
Frequently asked questions
Does the cutting sample also approve the insulation performance?
No. Cutting geometry and the application performance of the material are separate inspection subjects.
Should the adhesive face be specified in the drawing?
Yes. Face, direction, and preserved liner information can affect part mating.
