ÖZKARDEŞLER · Textile parts
Why are direction and layers specified together in fabric and felt cutting dies?
Even if the contour of a fabric or felt piece is correct, the result of sewing and assembly may change if its orientation is wrong. Therefore, when requesting a cutting die, not only the part dimensions but also the face, pattern, orientation, and layer arrangement must be visible.
Add the application orientation next to the contour
Indicate the front and back faces of the part, the pattern orientation, and the stretch direction if any, on the drawing. Do not leave mirror-image parts ambiguous under the same code. Also show the areas to be sewn or glued to another surface.
Not every material behaves the same way. Felt, woven, and coated textiles should not be grouped under the same name. The product description, thickness, and sample must be included with the file.
Do not count the number of layers as capacity on its own
Write down the expected number of cut layers, but do not assume this number represents a tooling capacity independent of the material and machine. The placement, compression, and post-cutting separation of the layers are also evaluated.
If there is a previously cut successful sample, indicate which production layout it came from. Do not use a test performed with a different material or a different number of layers as an acceptance example.
Put edges and small parts on the checklist
Internal holes, narrow necks, and small parts must be readable separately on the drawing. Explain the acceptable appearance at the edge and the expectation for fiber or part separation with an example. If a contour change is required, evaluate its counterpart in assembly as well.
- Part codes and right-left matching.
- Final drawing with marked orientation.
- Material sample and layer expectation.
- Cutting machine and acceptable sample.
Evaluate your fabric and felt part request with Özkardeşler over the sample. The appropriate tooling scope and trial conditions are determined after the material and machine information is completed.
Frequently asked questions
Is a leather cutting die directly adaptable to fabric?
The same tooling solution is not accepted without examining the material and cutting layout.
Can right and left parts be produced from the same drawing?
It is checked along with part geometry and material face; orientation information must be clear on the drawing.
