ÖZKARDEŞLER · Industrial cutting
how to specify diameter and hole pattern in abrasive disc cutting dies?
Two abrasive discs with the same outer diameter may have different center and vacuum hole layouts. The number of holes alone does not define the layout. Distances from the center, angular positions, hole diameters and orientation reference, if any, must be shown on the dimensioned drawing. Numbering the holes on the sample sequentially makes it easier to match the photograph with the drawing.
Separate the abrasive surface from the backing layer
Abrasive grain, backing paper or cloth, film and adhesive or bonding layer are not the same material information. Share the total thickness and the actual sample to be cut. Since the abrasive structure can affect the operating conditions of the cutting edge, rule selection and maintenance expectations must be handled through the sample. Just the grit number does not provide enough information for die selection.
Plan the exit of internal waste
A large number of small holes creates the need for waste extraction separate from the outer perimeter. If hole slugs remain in the die or product, it can disrupt production even if cutting takes place. Sheet layout, areas between holes and part separation are evaluated together with the machine. The same hole spacing or the same rubber arrangement is not recommended for every layout.
Check functional matching on the sample
Compare the cut disc with the target connection arrangement; verify hole counterparts and centering. Keep symptoms such as outer diameter, tearing, burrs and delamination in the same inspection record. First-part approval must be based on the result in the actual material, not just a screen capture of the drawing.
Checklist for quotation and evaluation
- Dimensioned diameter and hole map
- Layer structure, thickness and actual abrasive sample
- Machine, sheet and blank plan
- Critical dimensions and acceptance sample
