ÖZKARDEŞLER · Jigsaw puzzle applications

Check part matching and sheet layout together in jigsaw puzzle cutting dies

In jigsaw puzzle cutting, the boundary of each piece is related to the neighboring piece. The fact that a single piece looks good does not show that the entire tooling works correctly. Die preparation must begin with an approved full layout where pieces are seen together.

Share the entire layout instead of a single piece

Prepare a drawing separating outer contour and inner piece boundaries. Piece count, total dimension and print reference position must be understood in the same file. Clarify overlapping or ambiguous boundaries before production.

Applying a change made on a master drawing to only the relevant piece may affect matching with the neighboring piece. Revision approval must cover changing boundaries and the total layout together.

Describe material and surface layers

A paperboard, rigid board or foam-based structure may not show the same cutting behavior. Thickness, print/laminating layers and coating information, if any, should be shared along with the sample. The commercial name of the material alone may not be sufficient.

Demonstrate expectations for piece separation, rejoining and edge appearance with examples. Do not assume that a single gap or tie dimension can be applied to every material. The machine and tooling structure to be used are also examined.

Provide approval over a fully cut sample

  • Approved total layout and piece count.
  • Print reference and latest revision.
  • Actual material and all surface layers.
  • Machine information and piece matching expectation.

Discuss your puzzle die project over the entire layout with Özkardeşler. Let us determine the outer contour, inner boundaries and results to be checked on the sample together before quoting.

Frequently asked questions

Is piece count alone sufficient for pricing?

Total contour, geometry, material and tooling scope are also evaluated.

Does a print PDF replace a cutting drawing?

Piece boundaries must be dimensioned and clearly defined; print appearance alone is not sufficient.

Explore other cutting die technical guides