ÖZKARDEŞLER · Electronic components
Layer alignment in membrane switch and graphic panel cutting dies
The outer contour of the graphic panel, window opening and cutting of the adhesive interlayer may not be the same job. Describe PET or PC film, print, adhesive, carrier liner and other layers separately. The role of each layer is as important as the total thickness. The die does not replace electrical circuit design or switch function approval.
Standardize the register reference
The positions of printed icons, display window and mounting holes must be read from the same reference. Match the revision of the cutting drawing and the graphic file. Even if only a single hole changes during operation, specify which version all layers match. Precise hole locations must not be derived from a photograph without an approved dimensioned drawing.
Separate through-cutting from cutting that protects the liner
In an adhesive panel, peeling off the top layer while keeping the carrier intact may be required. In another product, all layers will be cut together. Indicate this expectation on the drawing and sample. Liner damage, adhesive migration or separation at the layer edge are different inspection symptoms.
Include assembly trial in approval
The seating of the panel onto the target surface, window position and edge alignment are checked in the sample assembly. Expectations such as ease of removal, surface marks or adhesive overflow are also recorded separately. By sending the layer list and actual sample to Özkardeşler, you can determine the cutting die scope, critical dimensions and inspection method together.
Checklist for quotation and evaluation
- Layer list and thicknesses
- Same revision of graphic and cutting
- Assembly references, holes and windows
- Through/kiss-cutting expectation and liner sample
