ÖZKARDEŞLER · Elastomer cutting
Why the sample is decisive in rubber and EPDM cutting dies
EPDM, rubber, silicone, and polyurethane-based elastomers are not evaluated with a single cutting recipe. The product class, hardness information, actual thickness, and reinforcement and adhesive layers, if any, are shared together. The difference between spongy and solid structures must also be specified. A technical datasheet provides a starting point; an actual sample helps demonstrate cutting and part separation behavior.
Separate the cut part from the trapped waste
Flexible material may deform during measurement. Under which conditions, with which reference, and with which acceptance limit the dimension will be checked must be discussed beforehand. Supporting the material and separating it after cutting, just like the geometry of the rule, can affect the result. Assigning a fixed cutting-rule height or pressure value to every material is not correct.
Internal holes and thin bridges are evaluated separately
Slugs of small holes in gaskets or protective parts may remain in the die, and narrow areas may stretch during stripping. Mark hole centers, internal contours, and critical thin areas in the drawing. A clean cutting edge and a dimensionally accurate part are evaluated in the same check. Also specify the type of symptom in a problematic sample.
Do not turn a condition of use into a performance promise
The preparation of the cutting die does not automatically approve the part's sealing, chemical resistance, or temperature suitability. Material and application approval are determined by the relevant technical authorities. Send the material to be cut, approved drawing, machine, and sample to Özkardeşler; let us evaluate the die scope according to the actual production requirement.
Checklist for quotation and evaluation
- Material code, hardness, and actual thickness
- Layers, adhesive, and reinforcement information
- Internal/external contour and critical hole centers
- Measurement condition, acceptance limit, and actual sample
