ÖZKARDEŞLER · Label cutting rule
8 mm and 12 mm label cutting rule: how should you specify the height?
Phrases like 8 mm label cutting rule, 12 mm label cutting rule, or barcode cutting rule can be a starting point in an order. However, do not assume that there is a single universal height and point size for every barcode label. The manufacturer code, total height, thickness of the steel rule, and the machine on which it will be used must be verified together. The label and technical drawing of the existing tooling reduce misunderstandings.
Total height and protrusion are not the same thing
Cutting-rule height is the total measurement from the base of the steel strip to its cutting edge. The portion remaining above the backing board is another measurement related to setup. Without knowing the plywood thickness and how the rule sits, the two cannot be considered equal. Marking which two points the measurement belongs to on a PDF or photograph is clearer than just saying 12.
Point size describes thickness
Height and thickness are separate ordering areas. Match the rule thickness given in points with the manufacturer's millimeter equivalent and product description. Thin contour, tight radius, cutting edge, and material structure are evaluated in the same selection. The suitability of one dimension does not show that all other technical specifications are also suitable.
Specify the cutting target together with the liner
If you want the top layer to be cut while protecting the liner in sheet labels, write this clearly. Through-cutting and kiss-cutting requests require different checks. Alongside the expression of coated, thermal, PP, or PET label, the adhesive, liner, total structure, and actual sample are required. Place your order by clarifying the rule selection and sample check together.
Checklist for quotation and evaluation
- Total rule height and point size
- Manufacturer/product code and existing tooling information
- Machine, carrier, and counter-cutting arrangement
- Label, adhesive, liner, and through/kiss-cutting target
