ÖZKARDEŞLER · TECHNICAL NOTES

From Thermoforming Sample to Cutting Line: Define the Target Edge Correctly

Evaluate the physical sample, final edge, remaining flange, and seating references together during thermoforming cutting line preparation.

The existing outer edge of a formed plastic sample is not always the targeted finished edge. Before preparing the cutting line, clarify which region will remain on the product and how the part will be positioned.

Separate the final edge from the sample

Clearly define the finished outer dimension and the flange to be preserved. If the part will sit in a recess, add the relevant assembly reference. Directly copying the existing sample edge may carry deviations formed in previous production into the new drawing.

Include the seating method in the measurement

Specify which surface the part will be supported from. Check opposite edges and corners from common references. Record the dimensions in the free state separately from the supported position dimensions representing production; verify the method to be applied for the project.

Compare multiple samples

Examine perimeter and flange variation on different samples if possible. Do not accept local deformation on a single part as the target geometry of the cutting die. Evaluate cutting allowances together with product expectations and observed sample differences.

Complete the drawing with clear information

Prepare the cutting contour as a clean and closed vector. Add the top face, part orientation, reference points, and remaining flange information. Clean up repeated lines; associate the approved revision with the physical sample.

Share for evaluation

• Physical sample and current product information.
• Final outer dimensions and remaining flange.
• Seating surface and directional references.
• Drawing and sample differences and revision notes, if any.

Share your sample and target dimensions with Özkardeşler; let us clarify cutting line needs together.

Explore other cutting die technical guides