ÖZKARDEŞLER · TECHNICAL NOTES
Creasing Channel Selection: From Paperboard Thickness to Folding Test
Evaluate actual paperboard thickness, cutting rule, grain direction, and the folding test performed with the finished material together during creasing channel selection.
Proper folding of paperboard cannot be evaluated with grammage information alone. The width and depth of the creasing matrix must be considered together with the actual material, the creasing rule used and the folding expectation.
Verify thickness first
Take measurements at different points on the paperboard to be used in production. Record the lowest and highest values. Do not assume paperboard of the same grammage has the same thickness; note any batch or surface treatment variations.
Separate width and depth
Channel width affects the forming area around the crease, while depth affects the clearance for this movement to occur. Compare the toolmaker's technical recommendations and material data before trying to fix an incompatibility in one by changing the other. Do not use a single channel dimension valid for every job.
Test the grain direction and finished surface
The result obtained on plain paperboard may not represent the laminated or varnished surface. Perform the proofing with actual production material. Examine creases in different directions separately; record surface cracking, crushing, and crease formation.
Try changes one by one
The appearance of the defect guides the investigation; it does not indicate the exact cause on its own. Evaluate channel, tooling, and pressure conditions together. Compare the result by changing a single variable in each trial; keep the approved sample with setup notes.
Prepare for evaluation
• Actual paperboard and thickness measurement range.
• Grain direction and surface treatment information.
• Creasing rule and existing matrix information.
• Folded sample and defect photos.
Share your paperboard sample and creasing knowledge with Özkardeşler; let us clarify folding requirements together.
