ÖZKARDEŞLER · TECHNICAL NOTES

See Material Behavior in the Sample for Foam Separators

Evaluate cavity fit, material structure, and post-cutting spring-back together with the actual sample in EVA and sponge separators.

The dimension of a foam separator on the drawing and its behavior after cutting are not the same evaluation. Examine product fit, cutting edge, and material spring-back together.

Do not define the material only by its name

Along with EVA, PE foam, or sponge information, share the thickness, available density data, and material sample. Do not consider density as the sole indicator of hardness. Cell structure, surface, and compression behavior also contribute to the evaluation of the cutting method.

Test the cavity with the product

Examine whether there is any strain when placing the product, catching when removing it, or crushing on the edges. A through-cut cavity and a closed-bottom pocket are not the same structure; specify the required depth and layer arrangement. Repeat the measurement after the specified resting conditions.

Verify the cutting method with the application

The blade, backing, and stripping arrangement must be evaluated with the actual material. If there is an incomplete cut, slanted wall, or surface mark on the bottom face, record them. Check the desired fit quality and sheet layout together in the sample; do not approve protection performance solely by looking at a neat edge.

Let us clarify your needs together

Share your current drawing, material, and sample information with Özkardeşler; let us evaluate the requirements of your application together.

Explore other cutting die technical guides