ÖZKARDEŞLER · TECHNICAL NOTES
Identify the Cause of Waste Remaining in the Stripping Channel
Differentiate between waste bound in the stripping channel and waste cut and jammed; evaluate the sample, cutting contour, and material together.
Seeing waste in a waste stripping channel does not necessarily mean that the cutting was incomplete. The waste may have remained attached to the material or become jammed in the channel despite being cut.
Inspect the waste without removing it.
Photograph the processed sheet before cleaning. Check both sides of the channel and the closed end separately. Mark points with fiber connections as well as sections that are free but fail to come out. Record whether the problem recurs across all cavities or at a specific position.
Perform a technical check according to the symptom.
For attached waste, cutting joints, rule seating, and the planned nick arrangement can be examined. For free but jammed waste, the clearance gap and the working behavior of the rubber used are evaluated. Treat these not as definitive diagnoses, but as checking points to be tested with the sample.
Consider assembly without modifying the channel.
Share the actual board thickness and flute direction, if any. Widening the channel simply to make waste exit easier can alter the fit tightness. If the geometry is going to change, revise the drawing; check the installed state of the stripper along with cutting cleanliness.
Let us clarify your needs together
Share your current drawing, material, and sample information with Özkardeşler; let us evaluate the requirements of your application together.
