ÖZKARDEŞLER · TECHNICAL NOTES
Need for Replacement in Ejection Rubber: Read Symptoms Along with Production Results
Evaluate permanent crushing, surface changes, and parts getting stuck in the die regarding ejection rubber together with rubber arrangement and actual cutting samples.
The cut piece staying in the cutting die or forming marks on the paperboard cannot be explained solely by the condition of the cutting rule. The surface, return behavior, and placement of the ejection rubber must also be included in the inspection.
Monitor permanent deformation
Record crushed, cracked, torn, or significantly altered surface areas. Evaluate the recovery of the rubber after pressure according to its technical specifications. Do not expect the same return behavior from different rubber types; do not make a definitive decision based solely on appearance.
Mark the issue on the cutting die
Does the piece always stay in the same corner, or does waste accumulate in a certain area? Match problematic layouts with the sample. Examine rubber height, distance to the cutting rule, and placement together with actual material. Do not assume adding harder rubber will be the solution in every case.
Compare marks and cutting behavior
Compare crushing or wrinkling on the paperboard with a sound sample. Also evaluate cutting rule condition, material, and machine conditions. Without attributing a single symptom solely to the rubber, record where and under what conditions the problem repeats.
Verify the scope of renewal
If regional processing is considered, evaluate its compatibility with the existing setup. If there is widespread aging or irregular additions, re-examine the entire layout. Perform proofing with current material after processing; add the date, changed area, and result to the cutting die record.
Share for evaluation
• General and close-up photos of the cutting die rubber.
• Sound and defective cutting samples.
• Material and existing rubber information.
• Problematic layouts and previous processing records.
Share your cutting die and cutting sample with Özkardeşler; let us evaluate your production requirement together.
