ÖZKARDEŞLER · TECHNICAL NOTES

Kiss-Cut Test in Label Dies: The Liner Must Be Protected When Peeling Labels

Evaluate the kiss-cut test on label dies with actual material. Key points to watch for clean release, liner control, and sample approval.

The goal in kiss-cutting is to cut the label layer while protecting the liner underneath. The result cannot be understood solely from the appearance of the cut shape; the peeling behavior of the label and the condition of the liner must be examined together.

Evaluate the test with actual material

The label face, adhesive, and liner together form a material structure. Define the material to be used in production during sample preparation; do not consider results obtained with a different material as direct production approval.

How is the label peeling off?

Carefully lift the label from the liner. Observe whether there is any snagging, tearing, or unwanted lifting at the edges. Also check the separation of surrounding waste if applicable. Instead of selecting only the best-looking example, inspect different regions of the sample.

Check the liner separately

Inspect the underlying surface after the label is removed. Record any signs of cutting, puncture, or tearing. Do not assume that a label that looks clean at first glance also has a suitable liner.

Record the result

Store the material code, the sample used, the observed issue, and the approved version together. Clarify with the technical team whether the test needs to be re-evaluated when the material changes.

Your sample evaluation checklist

• Is the production material clearly defined?
• Do label edges separate cleanly?
• Does the liner remain intact?
• Is waste stripping behavior appropriate, if applicable?
• Are the result and approval information recorded?

Share your label material, drawing, and sample with Özkardeşler; let us evaluate the scope of your kiss-cutting needs together.

Explore other cutting die technical guides