ÖZKARDEŞLER · TECHNICAL NOTES

Source Check in Print-Cutting Misalignment: Measure Before Revision

Measure consecutive sheets in print-cutting misalignment; evaluate the need for revision using file, print, die geometry, and feeding checks.

The shifting of the cut relative to the print does not necessarily indicate that the die is faulty. File references, print position, die layout and sheet feeding are different parts of the same investigation.

Measure the repetition of the deviation

Compare consecutive sheets from the same reference corner. Record the direction and amount of shift using the same method. A constant deviation versus a deviation that changes from sheet to sheet helps determine the check sequence; it does not show the exact cause by itself.

Compare the four sources together

Examine the approved print PDF, cutting drawing, fully printed sheet and cut sample in the same orientation. Verify the page size, grip margin and reference corner. Equalizing only the product center may mask the difference in the sheet reference.

Examine the die geometry independently

Compare the cutting contour and critical intervals with the drawing on a suitable unprinted sample. If the geometry is compatible, evaluate the die layout, print position and feeding separately. Clarify the source before compensating for a file or print deviation with a permanent geometry change.

Change a single variable in each trial

Record the adjustment made and the measurement result. Keep the initial, corrected and approved samples in the same job record. Use these records as a starting reference in repeat production; re-verify current material and settings.

Share for evaluation

• Print and cutting files in the same revision.
• Consecutive fully printed sheets and cut sample.
• Reference corner, grip edge and deviation measurements.
• Material used and trial notes.

Share your sheets and current files with Özkardeşler; let us evaluate cutting needs together.

Explore other cutting die technical guides